CBR 900 RR 1993 noise

I just got a CBR 900 1993 and I have torn it down and started some work on it and I have afew questions...

1. will a 200 fit in the rear???
2.I get a noise at low to mid rev,s I was told it is a cam chain tensioner...if so where can I get one..
3. Ilowered the forks 1/2 inch on the triple tree will this caue any problems?
4. I am having problems with the turn signals, I believe it is the switch and want to know if anyone else has had this proble?

So far I have done the frame and motor black. I have added 8000 K  HID's and am getting ready to put some rearsets on it. I put some LED thru the plastic and carbon fiber and the sanded them down and cleared the part so you can not see the signals until they light up.

I shaved the turn signal holes and have covered the bike in Carbon fiber. I split it down the middle so the carbon would match on both sides. I am going to redo the rear section and cut the seat frame and raise the rear about 3 inches and narrow the rear end. I am going to add LED's in the rear with built in turn signals... I also wrapped the 2 Brothers exhaust in CF also

anyhow thats my start I am 40 now and my days of riding like a maniac are done (7 Kids) But I always liked the way the CBR looked so its more for Rec than daily. Its a good 2 up bike and when I want a little past 7000 grand seems to pull the bike into a stable single tire ride ;)

I left some pics so let me know what you think.


Thumbnail Image



Thumbnail Image



Thumbnail Image

Welcome to the site Ghusar. Dont know what to tell you regarding your bikes noise and tire fittment (I ride a 600). What I can tell you is; you laid that clear down like a champ!!!! I see that tank sitting on a body shop stand and pro masking materials so I figure this is not your first paint job! Well done. I also like the imagination that went into fitting the lights. Make sure to post some pics when it's completed. 

Thanks Its been a long time but yes I do own/run a body shop. I work on cars all the time www.intensepower.com

Thanks its always nice to hear someone compliment the quality of your work.


wait till I post some pics of the tail section I am hand making from CF with integrated LED tails and turns into it....

I had a  550 GPZ, 750 GPZ turbo, EX 500 , 600 Hurricane, 1000 Hurricane and a Ninja I bet that dated me...

so its been about 18 years since I have 2 wheeled it and man you dont know how bad I want to just put it back togather and just ride....

No phone, radio, kids... just you and well...freedom thats what it is...Freedom!