cjbettis
2/1/2006 1:30:12 AM
What do I do now? Dude I am so pissed off. I had the dealer throw some integrated lights for the front until my hotbodies came in. First of all, there were no running lights and they wouldn't blink.....never put resistors on.
But didn't care, only temporary, but check out the pic................
What the heck now?!?!!? Not only did they cut out any place to actually mount my Hotbodies lights, BUT they also cut so far back on the farining no matter what light I use a big frickin hole will show............
They asked if they could cut a little, because the hole wasn't quite big enough...assumed just the two little holes...not that they were gonna take half my fairing off.
Any suggestions for a fix in case they won't do crap, besides just buying new plastic?
thanks
in case unrecognizeable....use to be front light area....where one should be able to mount anything that would blink when turning
Thumbnail Image
shraz
2/1/2006 4:33:19 AM
y were there no running light in the first place?
take a pic abit back
Anubis
2/1/2006 6:46:32 AM
I think you`ve been royally ass raped mate, Unfortunately they`ll prob tell you its your problem because you asked them to do the job for you.
cjbettis
2/1/2006 12:33:08 PM
quote:
ORIGINAL: shraz
y were there no running light in the first place?
take a pic abit back
there were, but they were bigger than my new Hotbody lights....didn't find out about this until last night when went to switch them out
