Blue70
10/28/2005 10:12:26 AM
That was no fun at all!
I think it would have been easier to pull the motor to do it.
It only took about an hour, but would have taken a lot less time if you could get to it
I looked at the tutorial floating around before I did it, and it looks like the F4 has a lot more room to work than the F4i does
But it is fixed and don't rattle any more
vtec97hatch
10/28/2005 11:11:02 AM
how much tension are you supposed to put on the cam chain after replacing the cct?
OutToWin PAHC
10/28/2005 2:12:32 PM
did you buy this from me off ebay?
Tahoe SC
10/28/2005 4:30:24 PM
they don't have an exact measure of tension...what's been used is just turn in until noise is gone, then back out until you hear the noise again, and then 1/4 in...so not exact...all by ear.
the stocker, while noisy, still does it's job of putting the right amount of tension on the cam chain...it's just noisy. there's a way to fix this...
T
Blue70
10/28/2005 6:10:03 PM
Nope..
Didn't know you sold them
I picked up at a local shop for $55
Blue70
10/28/2005 7:06:31 PM
quote:
ORIGINAL: Tahoe SC
they don't have an exact measure of tension...what's been used is just turn in until noise is gone, then back out until you hear the noise again, and then 1/4 in...so not exact...all by ear.
the stocker, while noisy, still does it's job of putting the right amount of tension on the cam chain...it's just noisy. there's a way to fix this...
T
So what the hell is Honda waiting for?
Tahoe SC
11/1/2005 1:52:02 PM
not enough complaints mang...and no one is dying from this...
it's not like a firestone thang...
i think they focus on all the new skool stuff now...
