Need Help - Putting back on rear plastic

Hi Guys,

I am new to this forum and I am hoping that someone can help me. I managed to get the tail section off of my bike however now I can not put it back on if my life depended on it! Does anybody have any suggestions or detailed instructions on how to put it back together? Where do I even start? Any help would be greatly appreciated.

Thanks

Josh

you need to stretch out both sides(so i can go over the black plastic over the exhaust) and slide it in almost vertically from the rear. sorry no pics but you can figure it out. if you were looking at the left side of the bike, the motion would look like a down then left arrow.

the plastic will bend ALOT more than you think it will. it will go back on. i promise.

Ive had to take the back off my bike so many times. It will definately stretch. With these bike you pretty much have to take the back off to do alot of little upgrades and adjustments.

Everyone above is right bro! You gots ta bend a lil bite ta put it back on. Don't be skuurd! It'll go on jus fine!