bowtiepwr
5/4/2007 3:13:36 PM
>hey all,
I just attempted to install my Power Commander on my CBR 1000RR and now the engine just cranks and won't fire. I connected the black wire to the battery (negative terminal side) and connected the fuel injector harness to the correct ones starting with the orange on the left side injector.
then connected the TPS sensor... but now it just cranks
what am I doing wrong?
Thanks for the help.
Does the PC power up when you turn the key on?
Do you hear the fuel pump priming?
I had the same problem when I installed mine, because I took my whole bike apart to get to some other stuff.... Turns out you had to have the headlight plugged in... I dunno if its the same on your bike (mine is a '04 f4i), but its something to think about.
bowtiepwr
5/4/2007 4:43:38 PM
>OK I figured it out with the help of DynoJet Tech Support.
it was me hooked up to a connector not the TPS like I thought I am very experianced at taking on and off the mid panels :)
bowtiepwr
5/4/2007 4:47:37 PM
quote:
ORIGINAL: pell
Does the PC power up when you turn the key on?
Do you hear the fuel pump priming?
I had the same problem when I installed mine, because I took my whole bike apart to get to some other stuff.... Turns out you had to have the headlight plugged in... I dunno if its the same on your bike (mine is a '04 f4i), but its something to think about.
>Thanks for the suggestion, but it was me. I had something other than the TPS connected.
I now need my Yoshimura RS5 slip on and I will be all set... for now.
