Removing factory reflectors

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

Removing factory reflectors

Printable Version

CBR >> Current Honda CBR Models >> CBR 600F4i >> Removing factory reflectors

Page: [1]

Message

<< Older Topic Newer Topic >>

Removing factory reflectors - 6/2/2005 11:06:08 AM

killersworld

Posts: 1
Joined: 6/2/2005
Status: offline

Hey quick question for you guys. I want to remove all the factory crap refectors and was wondering if you guys drilled them out or is there a special tool. Just want to know before I destroy my bike while trying.

Thanks

Killer
2002
Honda F4i

Post #: 1

RE: Removing factory reflectors - 6/5/2005 5:53:30 AM

TooL

Posts: 173
Joined: 5/16/2005
Status: offline

My bike just had a reflector on the tail right under the license plate. All it took was removing the plate and then the 3 screws under it that connect the reflector to the fender and that was pretty much it.

(in reply to killersworld)

Post #: 2

RE: Removing factory reflectors - 6/5/2005 5:57:09 PM

marcee77

Posts: 88
Joined: 5/5/2005
From: NY
Status: offline

whats up- if your talkin about the two red reflectors on either side of the tail section- they are held on by really weak rivets, I just twisted mine a few times then pulled them off. You are left with little holes abd some bent plastic but in a very unseen spot and I just used the back end of a screwdriver to push the bent plastic up into the tiny holes.

(in reply to killersworld)

Post #: 3