wont push start

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

wont push start

Printable Version

CBR Forums >> Past CBR Models >> CBR 1000F "Hurricane" >> wont push start

Page: [1]

Message

<< Older Topic Newer Topic >>

wont push start - 9/30/2006 10:33:34 AM

tdragon

Posts: 2
Joined: 9/30/2006
Status: offline

ok i got a 88 1000f for free from a friend it ran when i picked it up but the starter went. and the batterys dead so i tried to push start it but when i let the clutch out it just locks up the rear wheel. im not a little guy at 290lbs but the rear wheel will just lock up i have like an 8foot skid from when the tire locked up any suggestions?
thanks

Post #: 1

RE: wont push start - 9/30/2006 10:37:47 AM

Trips

Posts: 801
Joined: 3/31/2005
From: Perth (Western Australia)
Status: offline

Try second.

Also bikes are dam hard to pushstart unless you are sitting on the seat so there is some weight over the rear wheel.

Finally the cbr wont push start unless there is at least some juice in the batter to power the CDI.

_____________________________

Remember the light at the end of the tunnel may be an oncoming train!

(in reply to tdragon)

Post #: 2

RE: wont push start - 9/30/2006 11:41:10 AM

Chuck Norris

Posts: 125
Joined: 9/11/2006
Status: offline

Did you try putting it in second or third gear? First gear has too much mechanical advantage to turn the motor over. Using second or third gear reduces the torque of the motor... plus it'll turn the motor faster than if the bike was in first. You said the starter went out?.? You can try tapping lightly on the starter with a small hammer and try to turn it over. Sometimes things wear out and lock up, but usually they wear out and get in a bind before they lock up. Tapping on it might loosen it up. If the battery is dead and you don't have a battery charger handy our bikes run on a 12-volt electrical system. So do most cars... you should be able to use some jumper cables to jump-start the bike also. Hope this was some help. Just don't try to pull start it

! I knew an idiot that did it with his dirtbike. When he dumped the clutch the bike finally started and did a wheelie in =to the back of the truck at 45mph! The guy was alright but it's kinda funny to look back on.lol! Good luck on getting your free-be running!!!!!!

(in reply to Trips)

Post #: 3

RE: wont push start - 9/30/2006 3:43:00 PM

tdragon

Posts: 2
Joined: 9/30/2006
Status: offline

ok i figured out the starter is fine but when it goes to start it locks up. it locks up in the motor can anyone help

(in reply to Chuck Norris)

Post #: 4

RE: wont push start - 9/30/2006 5:48:45 PM

MarkR

Posts: 975
Joined: 8/20/2005
From: Gold Coast, Australia
Status: offline

quote:

plus it'll turn the motor faster than if the bike was in first

The engine should turn slower in second.

I would put it in 6th just to see if the motor will turn over, are you sure the starter is not seized and engaged to the engine
and you do need some charge to the battery for the CDI, but I would be a bit concerned about if the motor is not seized before worrying about batteries and stuff

(in reply to tdragon)

Post #: 5

RE: wont push start - 10/1/2006 1:38:17 AM

j0el

Posts: 35
Joined: 9/8/2006
From: NSW, Australia Bike/s: CBR1KF, CB250N
Status: offline

put the bike in 5th gear, get it rolling clutch in and let the clutch out. if it still locks up, the motor may just be seized.

_____________________________

enthusiasm outweighs ability
Connecting Riders in Australia

(in reply to MarkR)

Post #: 6