Engine upgrades...
Login  | |
|
Engine upgrades... - 6/26/2007 12:20:47 PM
|
|
|
Harry
Posts: 111
Joined: 12/5/2005
Status: offline
|
Hey, I guess this is the right place to post this.
I have a cbr600f2 engine that I am planning on putting in a streetfighter I am currently designing, and I'm at the stage where I want to start getting it ready for the bike. I was just wondering if someone could point me in the right direction as to the more streetable mods that will give me reasonable power gain without compromising driveability. I mean anything, such as clutches, pistons, cams, what will be the best bang for the buck. I'm looking to have a bike that has comparable numbers to a more modern bike. Oh, and I will be fuel injecting it already, with an aftermarket can on somewhat shortened headers.
Thanks
As a matter of fact, what are the numbers of the stock engine?
|
|
|
|
|
|
|
RE: Engine upgrades... - 6/27/2007 6:12:33 PM
|
|
|
f3racer
Posts: 1022
Joined: 6/27/2007
From: ft stewart ga, orlando fl
Status: offline
|
well im not sure what to tell you about engine internals. but remember his the original f2 was 447lbs only 2 lbs more than the 03 600 rr when it came out. it had 87 hp 42 lb ft. i have a 96 f3 street fighter. it has a stage 3 jet kit, k&n, m4 exhaust, vortex 520 conversion with 1 down up front, factory ignition advancer adv 3 degrees, and all the work and dyno tuning was done by full spectrum racing in orlando florida. the dyno run was 109 to the rear wheels. now i bought the bike used so im not sure what might have been done internally but this is a strong motor. the bike weighed in at 423 full of fluids so its about 8 lbs lighter than an 06 600 rr. the fuel injection your putting on should be good for atleast 3 hp with out any other mods. ive been looking all day for piston and cam kits for my f3 and havent found much. but heres a spec listing for most bikes 97 and newer just to give you examples.
http://www.motorcyclistonline.com/performancedata/#honda
|
|
|
|
|
Printable Version
