Dynojet company question

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

Dynojet company question

Printable Version

CBR Forum >> Past CBR Models >> 600 Modifications >> Dynojet company question

Page: [1]

Message

<< Older Topic Newer Topic >>

Dynojet company question - 12/9/2007 7:27:03 PM

camoweasel

Posts: 156
Joined: 6/28/2007
Status: offline

Does Dynojet actually dyno test each of the bikes they develop kits for? It seems to me like that would be alot of research time. Anybody can post dyno charts on the internet but are they actually the real charts pretaining to that bike model? Basically what I'm asking is, do you think Dynojet actually had a CBR00F1 while they were doing their research and development or were they just guesstimating when developing a jet kit?

_____________________________

1990 Honda CBR600F
K&N filter (removed air tubes under lid)
Yoshimura header with Vance & Hines SS2-R muffler
Factory Pro 6 degree Ignition Advancer
jetted

Post #: 1

RE: Dynojet company question - 1/5/2008 3:14:11 PM

stang68

Posts: 62
Joined: 11/15/2007
Status: offline

ok heres how it works thay have a block with that block thay have all the parts to chang it to cab and injeted with taht thay can use a F1 carb ste up and see waht works best use taht for a kit than change it to a f2 setup and see wat works best thay dont do the hole bike use the blocks from than and the kits oare pritty esy to install iv dun 2 so far

(in reply to camoweasel)

Post #: 2