Datatool DiGi gear indicator HELP

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

Datatool DiGi gear indicator HELP

Printable Version

CBR >> Current Honda CBR Models >> CBR 1000RR >> Datatool DiGi gear indicator HELP

Page: [1]

Message

<< Older Topic Newer Topic >>

Datatool DiGi gear indicator HELP - 12/31/2007 1:48:48 PM

jwp6114

Posts: 450
Joined: 2/14/2005
Status: offline

Does anyone have any technical info for troubleshooting these devices?
After my stator went bad a while back i have not been able to re-program my DiGi. I got rid of the crimp connectors and solderd all of the connection. Still no joy. I get the flashing "P" when i turn on the ingnition. not the "0" i should. and when i hold the program wire to ground "5 min +" it does nothing still flashes "P". and when i brush the program wire to ground to teach it how manny gears i have it just flashes to 1 then 0 then back to P. over and over again. verry frustraiting. any advice. I'm about to shit-can it. 04 1000RR

_____________________________

Post #: 1

RE: Datatool DiGi gear indicator HELP - 1/1/2008 10:22:19 PM

letsride

Posts: 390
Joined: 10/11/2007
From: Waterford,Ca.
Status: offline

Did you reset it?Try disconnecting the battery or the harness were you spliced your wires and reprogram it.

_____________________________

03 cbr 954 rr
Akrapovic bolt on
Bmc race air filter
Hass Eliminator
pcIIIr
pazzo levers
Life''''''''''''''''s a cycle ride it!

(in reply to jwp6114)

Post #: 2

RE: Datatool DiGi gear indicator HELP - 1/3/2008 11:03:19 AM

sweetdeal

Posts: 249
Joined: 12/9/2007
Status: offline

i am not going to lie i dont know anything about the unit itself, but what i do know is programming remote starts in a car, I had an alarm/starter malfunction, so to reset the unit I took out the "brian" module and "shorted" out the power comection pins,

to do this i completely disconnected it, took it out of the car and on the power plug side i used a small wire to touch each connection pin together at he same time this "shorts" out each capacitor inside draining the unit power competely like new, then you could reprogramm from the beggining. works fine to reset a remote starter, (just make sure you know how to reprogram the unit.)

(in reply to letsride)

Post #: 3