Next bikes gonna be fuel injected hate carbs (Full Version)

CBR Forum >> Past CBR Models >> CBR 600F

Next bikes gonna be fuel injected hate carbs

  

rebel3.0 -> Next bikes gonna be fuel injected hate carbs (5/30/2008 7:42:58 PM)

Ok guys. Got my carbs clean. Not once or twice, id say ive had them off 5 times now. Anyway there is somthing up.

In the morning she will idle fine . after a short drive , when stoped at a trafic light the idle will begain to jump up and down . If I do not blip the throtle the bike will stall. Riding it works fine, Except it will bog some times at 4000 - 4500 rpm?  Has anyone else have this happen? 

  
mitchedwards81 -> RE: Next bikes gonna be fuel injected hate carbs (5/30/2008 9:26:56 PM)

did you sinc them after cleaning and putting them back on.

rebel3.0 -> RE: Next bikes gonna be fuel injected hate carbs (5/31/2008 4:01:18 AM)

They havent been synced yet, i do plan to have it done tho. Would having them out of sync cause this much of a problem?

tripicana -> RE: Next bikes gonna be fuel injected hate carbs (6/3/2008 1:15:51 PM)

yes

mitchedwards81 -> RE: Next bikes gonna be fuel injected hate carbs (6/3/2008 1:56:52 PM)

do you know how to do them yourself?

rebel3.0 -> RE: Next bikes gonna be fuel injected hate carbs (6/3/2008 7:01:43 PM)

Dont have a set of guages . I really didnt think the carbs being out  would cause a rough idle like its doing . I was leaning towards maybe a intake leak ?

mitchedwards81 -> RE: Next bikes gonna be fuel injected hate carbs (6/3/2008 7:52:22 PM)

sit the carbs in front of you and look through the butterfly side, and see how much gap is at the bottom and set all of them the same. that is as close as you can get without gauges.

rebel3.0 -> RE: Next bikes gonna be fuel injected hate carbs (6/4/2008 3:47:53 AM)

ya actually i did that before i put them back . didnt see a diffrence, even measured it with a small drill bit.

89cane -> RE: Next bikes gonna be fuel injected hate carbs (6/5/2008 10:01:37 PM)

dude i had the exact same thing happen i pulled the carbs and put them back on probably at least 15 times and still didnt get it right i replaced the carbs and havnt had a simgle problem since. also check that on the number 2 cylinder that there is a air inlet of sorts and a hose connects it to the carburators i fixed that when i replaced my carbs with a used set and havnt had a problem since. did the bike work before you pulled the carbs or was it the same story then and thats why you tried to clean them.
hope that this makes some sense

Ryan

  

Page: [1]

Return to CBR Forum home page or view the Full Version of this page.