Where to hook up sync tool

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

Where to hook up sync tool

Printable Version

CBR Forums >> Past CBR Models >> CBR 600F4 >> Where to hook up sync tool

Page: [1]

Message

<< Older Topic Newer Topic >>

Where to hook up sync tool - 8/13/2008 2:40:36 PM

Aweasel

Posts: 363
Joined: 6/6/2008
From: Cincy, OH
Status: offline

So I made a manometer to sync my carbs but I''m not sure where the vacuum port/lines are I need to hook it up to. On other bikes and I''ve seen there is a port for this specifically but I don''t see any on our carbs. Anyone that knows where to start, I would really appreciate it.

The only place I could imagine to hook into is the small vacuum lines that go right behind each velocity stack on the air box.

_____________________________

99 F4...mostly.

“That which can be destroyed by the truth should be.”

Post #: 1

RE: Where to hook up sync tool - 8/14/2008 6:39:35 AM

DonEverett

Posts: 72
Joined: 8/25/2007
Status: offline

WHen you remove the lower part of the airbox, there will be 4 small rubber tubes connected to the back side of it. Those are the tubes you need to use. The ones not in use will need to be plugged.

_____________________________

99 F4 / Two Bros. Pipe / 520 Conversion (-1,+2) / Flush Signals / Pazzo Levers / Galfer Lines / Vortex Frame Sliders / K&N / Tinted Screen

(in reply to Aweasel)

Post #: 2