Getting stock lowering link off!

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

Getting stock lowering link off!

Printable Version

CBR Forum >> Past CBR Models >> CBR 954RR >> Getting stock lowering link off!

Page: [1]

Message

<< Older Topic Newer Topic >>

Getting stock lowering link off! - 9/4/2008 2:02:49 AM

djblaze247

Posts: 4
Joined: 9/4/2008
Status: offline

Need some tips on getting the actual stock link off my 954, I ordered the link and not the triangles and ran into a slight speed bump. I can''t get the stock link off because the I can''t slide the upper bolt out because it hits the exhaust bracket which is a part of the actual bike frame. Any help would greatly appreciated.

Post #: 1

RE: Getting stock lowering link off! - 9/4/2008 7:59:10 AM

not_agn

Posts: 27
Joined: 12/7/2006
Status: offline

I pushed the rubber grommet out and the bolt should fit through. Of course I had a micron full system so I didn''t use that mount anymore. If you have the stock exhaust you just need to move it out of the way and remover the rubber. Then reinstall and mount you exhaust.

(in reply to djblaze247)

Post #: 2

RE: Getting stock lowering link off! - 9/4/2008 11:33:53 AM

Bert

Posts: 74
Joined: 11/4/2007
Status: offline

yeah i did the same thing you need to get the rubber piece off and it will slide through.

(in reply to not_agn)

Post #: 3

RE: Getting stock lowering link off! - 9/8/2008 9:09:53 AM

djblaze247

Posts: 4
Joined: 9/4/2008
Status: offline

Thanx for the tip, that worked perfectly, my link also has a 4 inch setting but I can''t get it there because the shock hits the link at that point so I have it dropped 2 inches. any tips of how to get it to the 4inch setting?

(in reply to Bert)

Post #: 4