pops outta gear mid wheelie

CBR Forum Classifieds News Photo Gallery Search Member List Timeslips Contact Sponsors Register Login

pops outta gear mid wheelie

Printable Version

CBR >> Past CBR Models >> CBR 954RR >> pops outta gear mid wheelie

Page: [1]

Message

<< Older Topic Newer Topic >>

pops outta gear mid wheelie - 4/1/2005 12:31:53 AM

wheeliemonster

Posts: 20
Joined: 4/1/2005
Status: offline

I have an 03 954, sometimes when I wheelie 2nd gear my bike will pop out of 2nd and go into neutral. And other times it will pop outta 3rd gear back into 2nd mid wheelie, whats goin on???

Post #: 1

RE: pops outta gear mid wheelie - 4/2/2005 10:09:25 PM

FLYS2K

Posts: 13
Joined: 2/4/2005
Status: offline

I don't know, but it sounds scary. If it went from 3rd to 2nd mid wheelie, it would put you on your a$$ wouldn't it?

(in reply to wheeliemonster)

Post #: 2

RE: pops outta gear mid wheelie - 4/3/2005 1:19:50 PM

sirlimpzalot

Posts: 1404
Joined: 8/24/2004
From: Roseville, CA
Status: offline

Well your not gonna like this...
It sounds as if you have a bent shift fork..meaning that the part that engages the gears is worn ( probally and likely on bikes that are wheelied alot) and it is always 2nd gear that seems to be the first gear to be affected since the throw from 1st to 2nd is the longest, and it sounds as if the damage is fairly advanced since it allows it to skip back to 2nd from 3rd..
You have to replace the damaged parts ( usually it is at least three components) and unfortunately I believe you will be looking at a engine teardown to repair it. I dont believe the 954 has a cassette type transmission, which in conventional motorcycle engines the transmission is installed first, followed by the crankshaft and everything else. SO..if that is the case the disassembly is the reverse process; meaning the crankshaft will have to come out to access the tranny....the parts are not too expensive but the labor is the BIG part of this job

< Message edited by sirlimpzalot -- 4/3/2005 1:21:35 PM >

(in reply to wheeliemonster)

Post #: 3

RE: pops outta gear mid wheelie - 4/3/2005 3:12:01 PM

chainstretcher

Posts: 4552
Joined: 11/5/2004
Status: online

Limpy is correct -- sorry

$80 in parts $500 in labor.

_____________________________

It's better to burn out ...
Than high side!

(in reply to sirlimpzalot)

Post #: 4

RE: pops outta gear mid wheelie - 4/3/2005 3:15:46 PM

chainstretcher

Posts: 4552
Joined: 11/5/2004
Status: online

Need to add that your bike is only going to get worse and it won't take long. Eventually you'll either get it stuck in neutral or the fork will break and crunch some gears. Gears are expensive -- not to mention the safety factor of having the rear lock up if it breaks while pulling a wheelie. Get it fixed.

_____________________________

It's better to burn out ...
Than high side!

(in reply to chainstretcher)

Post #: 5

RE: pops outta gear mid wheelie - 4/4/2005 7:10:48 PM

SINITSA929

Posts: 13
Joined: 4/2/2005
Status: offline

either that or check your foot position if you put your left foot over the shifter you may be putiing just enough pressure on the lever to push the shifter lever down in to 2nd gear..it happens like when you power shift because you are constanltley adjusting the throttle it would be nice if thats it cause there is no labor involved just foot repostioning...hope thats it

(in reply to chainstretcher)

Post #: 6

RE: pops outta gear mid wheelie - 4/4/2005 11:36:50 PM

wheeliemonster

Posts: 20
Joined: 4/1/2005
Status: offline

Its never put me on my ass. It just comes down real hard. makes me look like an amature/ idiot.

(in reply to FLYS2K)

Post #: 7

RE: pops outta gear mid wheelie - 4/4/2005 11:42:19 PM

wheeliemonster

Posts: 20
Joined: 4/1/2005
Status: offline

Hope its not a tranny problem. I have 7kmi on the bike and have never adjusted anything such as the clutch cable. Do ya think it could be an adjustment like that? Ive had the clutch slip alittle once or twice also..... I put 13kmi on 2001 R6 almost every mile was a 2nd or 3rd gear wheelie using the clutch and I never had a clutch problem. Im actually surpriced to expeirience a problem like this on a litre class bike with more than enough power to wheelie... I appreciate all your comments and help, Thanks everyone.

(in reply to chainstretcher)

Post #: 8

RE: pops outta gear mid wheelie - 9/30/2005 8:17:29 PM

bobjoezx

Posts: 2406
Joined: 9/27/2005
From: Wisconsin
Status: offline

never really heard of that i would check ur clutch adjustment, and ur shift linkage and stuff like that does it do it everytime? waht about 1st gear wheelie's?

(in reply to wheeliemonster)

Post #: 9

RE: pops outta gear mid wheelie - 10/1/2005 3:33:57 AM

rr954ryder

Posts: 80
Joined: 8/16/2005
Status: offline

I had the same problem. 18,000 miles of wheelies. I opted for the motor swap rather than fixing it. mine got so bad that it wouldn't even engauge in 4th gear and the tranny made bad noise just riding around. the others are right, complete tear down, broken shift fork, broke or worn shifter drum, worn teeth on the gears.

_____________________________