1995 CBR600 F3 Race Bike
Login  | |
|
1995 CBR600 F3 Race Bike - 10/15/2008 8:41:29 AM
|
|
|
fullmetalf4i
Posts: 117
Joined: 9/21/2005
Status: offline
|
My race bike is going up for sale. Give me a few good seasons in the WERA V7 classes, and took my to a 2nd in V7MW, 3rd in V7HW and a 7th in C Superbike Novice in the North florida region. Ive got some post sesason engine work that I''ll do before it leaves.
Info on the bike
1995 CBR 600 F3
Bike used to belong to Erion Racing, and has Bill of Sale only
Electronics are the bare essentials for racing. No key, just push the button and go. It does have a starter and battery, but currently the batter loses power. Good for 5 or 6 starts on a charged battery (i just plug it into the battery tender after every race)
All the race essentials
520 chain and sprockets 43 through 46 rears
pro-tek rear sets
clip ons
steel braided lines
currently set up for GP shift but that is easily changed
fox rear shock
hrc black box
Autometer Tach up to 14k
pro-tek gas cap
bike is wired for WERA
swingarm spools
Extras:
1 front wheel w/ dent. Very fixable, there is a guy in Georgia that will do it for like $60, I''ve got my rain front on there just to put around for points, so it holds air, wheel also has rotors on it
1 rear wheel. The one on the bike has spray painted it silver because it is missing a small piece of rubber that helps hold the spacer in place during reassembly, other than this the wheel is fine and I would consider swapping it onto the bike and usinng the other wheel as a rain rear so you dont have to deal with the spacer ever tire change.
1 rear widened rear wheel. this came on the bike when i bought it. it allowed a 180 rear tire without ballooning it. It was widened by Erion racing (its just a strip welded in) so while it may kinda look like a ghetto job its very well done.
Gas tank (tank on the bike has a dent in the top, still plenty good, but its noted)
extra set of Carbs and extra jets and needles
Clutch plates
2 stock black boxes
some misc stuff as well
also have an f2 roller, its got bent forks but the wheels are straight, and the motor is good.
looking for $3200 for both bikes and all the spares
$2800 for the F3 with the spares
and $2300 for just the F3, no spares
clee826 at gmail.com
|
|
|
|
|
|
|
Printable Version
